**Comment restated:**

Section 8 on dynamic factor seems to have been updated to include the new ANSI/欧宝体育直播2015-1-A01 tolerance standard. The following paragraph comes from page 14 of that standard:

鈥淭he transmission accuracy level number, Av, can be estimated as the appropriate accuracy grade for the expected pitch and profile deviations in accordance with ANSI/欧宝体育直播2015-1-A01. See annex A for use with 欧宝体育直播2000-A88.鈥

ANSI/欧宝体育直播2015-1-A01. p.14

**Question 1:**

Does this standard (ANSI/欧宝体育直播2001-D04) numerically correlate the欧宝体育直播2015-1 accuracy class number with the value of Av? That is, if one has an 欧宝体育直播quality class A9 product, we are to select curve Av = 9 from figure 1?

**AGMA鈥檚 response:**

The value of pitch and profile accuracy class as defined by AGMA2015-1 may be used as the value for Av in absence of an evaluation of transmission error as discussed in the standard.

**Question 2:**

If this is the case, why is there a curve for Av = 12, when AGMA2015-1 only covers quality classes A2 to A11?

**AGMA鈥檚 response:**

The figure was constructed by re-labeling the curves in ANSI/AGMA2001-C95. Although accuracy grade A12 is not directly addressed by ANSI/欧宝体育直播2015-1-A01, there is no evidence that the use of the Av = 12 curve is not proper for lower accuracy gear sets (i.e., Av > 11).

**Question 3:**

Since 欧宝体育直播2015-1 has an applicable range of normal module 0.5 to 50 (i.e., normal diametral pitch 0.508 to 50.8), is the same module range represented by the graph in figure 1?

**AGMA鈥檚 response:**

Figure 1 is not limited as a function of module.

**Question 4:**

Section 8.3.3 shows an alternate method to estimate a value for Av in equations 25 and 26. Below equation 26 the following is stated:

鈥淧nd is normal diametral pitch (in-1), where 0.5 鈮 Pnd 鈮 20;鈥

Does this mean that the method is only valid if the diametral pitch is not finer than 20? What can one do if you have a fine pitch gear not specified according to 欧宝体育直播2015-1?

**AGMA鈥檚 response:**

Equations 25 and 26 are derived from ANSI/欧宝体育直播2015-1-A01 equations 3 and 4. They have the same range of application as ANSI/欧宝体育直播2015-1-A01 equations 3 and 4, i.e.:

- Accuracy grades A2 through A11
- 0.5 鈮 mn 鈮 50
- 5 鈮 z 鈮 1000 or 10 000/mn, whichever is less
- 5 鈮 dT 鈮10 000 mm